MicroNet SP888C Dokumentacja Pobierz pdf (Strona 78)

2009

2010

FURTHER INFORMATION

RJ45 SOCKETS

RJ45 PLUG

The untwisted length of a section of cable as the result of a termination to-

wards a connecting component must be as short as possible. Only the absolute-

ly necessary amount of wire must be unwound for terminating and finishing

the cable. Furthermore, for connections with category 5 components and above,

the detwisting of the cable must not exceed a length of 13 mm.

The two crimping methods are equivalent, but cannot coexist in a single in-

stallation. It follows that once the type of connection (A or B) has been cho-

sen for a cabling system, it cannot be changed.

The 100 Ω patch cord cable (flexible conductor), must be connected at both

ends with a modular male connector (plug), of the 8 position RJ45 type.

•

Follow the instructions regarding connection to the RJ45 jack.

When making up patch cords, we recommend following some simple pre-

cautions to optimise the operation of the system

• after crimping, check that the

cable is round in cross-section

within 6 mm of the connector.

• When using self-crimping sys-

tems, check that the insulation

has been properly perforated.

• In the case of screened cables,

the cable screen must be secure-

ly attached to the plug with the

specially provided collar.

For further information, request the FANTO

Net

technical manual.

23700

23724

23990

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 115 116

Brak uwag

MicroNet SP888C Dokumentacja Strona 78